Quick Test

Quick test for simple the use of DH-LAN.

Test Case 1 DH-LAN with IP camera.

1. Wiring

1 Camera

Open

Cameras

Open

2. Configure IP camera

IP address

For example:

IP: 192.168.243.180 Mask:255.255.240.0

Stream output

Main(1st) streaming: 1920*1080, H.264

3. Power up

Power up all devices

4. Setup

Menu for DH-LAN IP Camera

Tap “Settings” → “Ext.Unit” → “IPC camera”

Search and add an IP camera

Tap “Add by search”, tap the camera in the list, and input access to log in.

Tap “Save”

5. Check an IP camera view

Also further test video PIP in calling, see below:

Test Case 2 DH-LAN as the cable Internet connection.

Get internet with the DH-LAN connected to cable internet.

1. Wiring

2. Power up

Power with router connected.

3. Setup

3.1 Monitor Address Setup

This refers to the “DH622/DH850/DH821” test guide setup address; monitor in addresses 1 and 2.

3.2 Modify APP network to “LAN”

On the monitor, tap “Settings” → “Manager”, tap “Wi-Fi switch” to ON, and select the Wi-Fi name in the list, input the password, and connect.

3.3 Connect to VDP APP and test.

Refers to “DH622/DH850/DH821” test case “APP”

Test Case 3 DH-LAN as capacitor/distance extend

The capacitor of one 2-wire loop is 16 monitors, which needs more monitors, the additional accessory will require, usually DH-SW4, but you could use DH-LAN with a LAN switch too.

1. Wiring

2. Before Power up

Make sure all DIP on the DH-LAN module as configured shows, before powering up.

3. Power up

Power up all devices.

4. Setup and test

The setup and test are the same to DH850 Apartment Test Guide

No special setup but only more monitors are connected.

When creating a list, make a bigger list.