Instruction of BurnTool updated (use for DX2 devices)
- Jeff
Range of application:
This update is suitable for DX2 monitors (DX470、DX471S、DX482)
After updating , all settings will be restored to the factory default.
Preparation
PC : win7，win10，win11
Micro USB cable
Connect PC and Micro USB cable only , no need to connect the other side of Micro USB cable with device
Instruction of Update
Must unzip the specific model firmware which we sent , and open the FOLDER of firmware , you will find ‘BurnTool.exe’ software like picture 1 , double-click this exe file to run the software , you will go into the picture 2 interface.
Picture 1 | Picture 2 |
|---|---|
 BurnTool zip file with firmware
|
|
2. Keep holding the specific button at the back of specific monitor firstly, then connect the computer to the monitor with a Micro-USB cable, wait for 3 seconds and release the button. Then 3 seconds more the firmware will be updated automatically (it takes about 2mins).
The position of specific button & usb connection for each device as below :
① is the position of specific button
② is the position of usb connection
Model | Position of specific button & usb connection |
|---|---|
DX470 |
|
DX471S |
|
DX482 |
|
The steps of updating:
step1 | step2 | step3 | step4 |
|---|---|---|---|
|
|
| The updating is succeeded when the software interface shows “Burn task complete“
|
BurnTool.exe software can support 4 pcs devices to update the firmware at the same time , but you need to press the specific button for each device individually. The progress of the updating in each device will show on the software interface “Device0 ~ Device3”.