...
2. IX-LIFT as relay actuator
IX-LIFT Connectors and Indicators:
| Table of Contents | ||||
|---|---|---|---|---|
|
...
Address setting: DIP switch for address settings.
...
RS485: Inner communication ports connect with IX-RLC or IX-LIFT
Wiring IX-RLC with IX-LIFT
...
Control Signal Outputs
...
IX-LIFT DIP switch and floors
IX-LIFT DIP switch:
...
Relays and floors:
Relay | RL1 | RL2 | RL3 | RL4 | RL5 | RL6 | RL7 | RL8 | RL9 | RL10 | RL11 | RL12 | RL13 | RL14 |
Floor | 00 | 01 | 02 | 03 | 04 | 05 | 06 | 07 | 08 | 09 | 10 | 11 | 12 | 13 |
IX-LIFT DIP switch:
...
Relays and floors:
Relay | RL1 | RL2 | RL3 | RL4 | RL5 | RL6 | RL7 | RL8 | RL9 | RL10 | RL11 | RL12 | RL13 | RL14 |
Floor | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 |
IX-LIFT DIP switch:
...
Relays and floors:
Relay | RL1 | RL2 | RL3 | RL4 | RL5 | RL6 | RL7 | RL8 | RL9 | RL10 | RL11 | RL12 | RL13 | RL14 |
Floor | 98 | 99 | 100 | 101 | 102 | 103 | 104 | 105 | 106 | 107 | 108 | 109 | 110 | 111 |
Connections
Connected to same network with IX devices:
...
Settings
Enable “lift control” and floor settings on monitor:
...
Private RLC time: Unlock via RLC card reader, the private floor release time.
Card data sync to IX-RLC:
On the IX850 with card data:
While in “Installer mode”, tap “Installer mode” “Installer mode” -> “settings” “settings” -> “Access cards” “Access cards” -> “Card data” –> “Sync to device”“Card data” –> “Sync to device”, select the RLC and tap “Start sync”“Start sync”