Lift control requires at least 2 modules

1. IX-RLC as main module

2. IX-LIFT as relay actuator

IX-LIFT Connectors and Indicators:

Open

Address setting: DIP switch for address settings.

Relay outputs RL1~RL14: 14 relays NC or NO output for lift control.

Relay LED(Under): relay output RL1~RL14 LED indicator. Lights on when trigger.

Card Read, IX-Lift connector: use for lift controller.

Power LED: Power led, lights while power on

RS485: Inner communication ports connect with IX-RLC or IX-LIFT

Wiring IX-RLC with IX-LIFT

Open

Control Signal Outputs

IX-LIFT DIP switch and floors

IX-LIFT DIP switch:

Relays and floors:

IX-LIFT DIP switch:

Relays and floors:

IX-LIFT DIP switch:

Relays and floors:

Connections

Connected to same network with IX devices:

Settings

Enable “lift control” and floor settings on monitor:

On monitor, tap “Settings” -> “Installer” -> “Parameter” -> “Others”

LIFT_CTRL_ENABLE: whether enable or disable lift control on this monitor.

DEVICE_FLOOR: Setup monitor’s floor and floor release time.

Public floor: Public floor, while tap RFID card on RLC card reader will release

Public time: Unlock via monitor, the public floor release time (NOT USE)

Public RLC time: Unlock via RLC card reader, the public floor release time.

Private floor: Private floor, while tap RFID card on RLC card reader or unlock via monitor will release

Private time: Unlock via monitor, the private floor release time

Private RLC time: Unlock via RLC card reader, the private floor release time.

Card data sync to IX-RLC:

On the IX850 with card data:

While in “Installer mode”, tap “Installer mode” -> “settings” -> “Access cards” -> “Card data” –> “Sync to device”, select the RLC and tap “Start sync”