Page Comparison

...

1. Connect device with ST-Link as below:

   

2. Install “sttoolset_pack32.exe”, and after install, click “ST Visual Programmer” in “Start” -> “ST toolset” to run the software “ST Visual Programmer”

   

3. Click “Configure ST Visual Programmer” as below. (if you are run this software first time, jump to step 4.)

   

4. with following window, select “ST-LINK”, “USB”, “SWIM” and “STM8L15xC8”, and click “OK”.

   

5. At the main menu, click on open to and located the firmware file:

   

6. On “Files of type:” select “All Files(*.*)”, and locate and select “embOS_STM8L_IX-850_V10_720P_20210922.hex” 

   

7. After all files loaded, click “Program current tab or active sector” as below:

   Image RemovedImage Added

8. After a while when you see below message, the update is finish:

   

Note: If fail to update with poping up “USB tool can’t communicate…”, it maybe because of power from USB is not strong enough. Please try to use a CAT5 cable to link IX850 to PoE switch to get the power. Then restart the update.

For more details, please watch the video by this link: https://1drv.ms/v/s!ApVgqTKy9CI-h202KEMuW8iUfe72?e=Hxtgxj