A demo for how to setup a VS system
This manual will show how to install below project for one family
2 x Door station IX610
2 x Monitor IX471S
Some IP Cameras
All monitors/door stations in default setting or brand new from box.
Using DHCP & Auto-IP
Planning project
Plan network
Planning all network related issues.
PoE switch selection
In this demo, there are at least 5 networks devices (Include IP camera), here we use an 8 port PoE switch in this demo.
Cabling
Wiring all cables, here we use Cat5 cable.(monitor in wireless connection is possible too)
IP strategy selection and setup
Planning your IP strategy, here we use DHCP or Auto-IP in this demo.
IP camera settings
According to IP strategy, we will need to configure all IP cameras as requires
Plan Call_Nbr
Planning Call_Nbr, this relate to how you configure devices.
Call_Nbr selection
In this demo, we only need to call with buttons.
Configure Project
Power on all devices
Before configure device, we will need to installed and power on all device.
Configure IP settings
In this demo, we are using DHCP/AUTO, which is default settings, skip.
Configure Call_Nbr
There are 2 monitors, on one of the monitors which will be master:
Setup “Name” in “Call_Nbr” setting menu.
Run “Auto setup wizard”, tap “Settings” -> “ExternalUnit” -> “AutoSetupWizard”
This is a “Auto setup wizard”, check “Call_Nbr, Settings in VS” for more.
Test with Project
Basic intercom function
Test with calling, monitoring, unlock doors.
Divert to APP
Test with APP to see if it works.(Do SIP config setting after internet connection is setup)
Maintain after installed
Add more device
In this demo, after new devices add, run “Auto setup wizard” once again to apply new devices.
Remove device
Simply uninstall device, noting needs to do with remove a device.
Replace device
In this demo, after replace device, run “Auto setup wizard”